Home > News > Content

Seam Welding Machine Control Box Use And Maintenance

Seam Welding Machine control box use and maintenance

The seam welding is a metal joint that forms a permanent bond. In welding, the weldment is pressed between the two welding wheels, turning the welding wheel to drive the welding parts and power, welding current through the welding parts of the local heat, the formation of overlapping solder joints to form a continuous weld, to achieve permanent welding. Light reaction for the box, such as cars, motorcycles fuel tank; barrels, such as oil drums and forming sheet workpieces such as rims, mufflers, radiators and other seam welding.

Seam Welding Machine control box by the two sets of single-chip microcomputer system control welding process and power heating process, it can quickly transform a variety of special resistance welding machine can also be transformed into a variety of high-power three-phase low-frequency heating power dedicated controller. So the three-phase low-frequency point, seam welder single-chip control box can be equipped with a variety of power at home and abroad three-phase low-frequency point, seam welder.

Seam Welding Machine maintenance

First, the whole machine: to always wipe the shell dust; with compressed gas and shovels in time to clear the internal dust and spatter; to pay attention to pneumatic and transmission agencies should always pay oil lubrication.

Second, the electrode: weldment contact surface should always keep clean, do not stick welding welding residue left, available grinding and replacement method to clean up;

Third, the transformer: to always check the faucet connector, to prevent leakage of faucet, so that the transformer damp. Found that the phenomenon of leakage to be promptly excluded;

Fourth, the use of a long time, the secondary winding and soft copper belt connection screws may be loose, every quarter to check and find loose, then tighten the loose screws in a timely manner; every month to regularly clean the splash on the transformer splash;

5, adjust the switch: the welder in the non-working state can be adjusted, remember that the work can not adjust the voltage switch; monthly to check the wiring switch screw is loose, loose tightening when the loose screw;

6, water system: to pay attention to the first open water valve after the welding machine, no cooling water when the use of welding machine; outlet water temperature should not be too high, the daily check the water temperature is not higher than 30 °, outlet water temperature is not higher than 50 °; to pay special attention to is that the daily use of the welding machine should be compressed air will be the remaining water inside the machine clean, so as not to freeze the winter water, causing water pipe cracking.